LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Cooling - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Engine Cooling - INGENIUM I6 3.0L Petrol (G2344343) >> Removal And Installation >> Electric Coolant Pump (G2422865) >> Installation

Electric Coolant Pump (G2422865): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the electric coolant pump.
    • Set the clip to the close position.
    • Connect the 2 coolant hoses to the electric coolant pump.
    • Connect the electrical connector to the electric coolant pump.
  2. Fill the engine cooling system with the correct amount of coolant fluid.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

scientia non olet · About LEMON Manuals