Charge Air Cooler Coolant Pump (G2423958): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the 2 brackets.
- Install the clip.
- Install the charge air cooler coolant pump.
- Install and tighten the bolt.
  Torque : 5.4 Nm
- Connect the 2 coolant hoses.
- Install the 2 clamps.
- Connect the electrical connector.
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Fill the engine cooling system with the correct amount of coolant fluid.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING