Auxiliary Radiator (G2453431): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Only complete the following step(s) if the component was previously removed.

Install the bracket to the auxiliary radiator.
- Install the auxiliary radiator housing.
- Install and tighten the 2 nuts and bolts.
  Torque : 9 Nm
- Install the auxiliary radiator.
- Connect the 2 engine coolant hoses.
Install the auxiliary radiator to the 4 clips.
- Install and tighten the nut.
  Torque : 9 Nm
- Install and tighten the 2 bolts.
  Torque : 9 Nm
- Install the wheel arch liner front section.
- Install the 4 screws.
  Torque : 5 Nm
- Install the 2 clips.
- Install the front wheel arch inner moulding.
- Install the 3 clips.
Vacuum fill the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING