Pinpoint Test F: Pcm Diagnostic Trouble Code Repair Actions P2B83 Dry Running
WARNING: This page is about a different variant/trim than selected.
- F1: PCM DIAGNOSTIC TROUBLE CODE REPAIR ACTIONS P2B83 DRY RUNNING 1
- Using the Jaguar Land Rover approved diagnostic equipment, check for DTC
P2B83 set in the PCM
Is the coolant pump running?
Yes: Intermittent fault - Check the cooling system for restrictions or blockages and bleed the system to remove any trapped air. GO to F2.
No: Disconnect the coolant pump link harness from both ends, Clean all terminals and pins with a suitable contact cleaner spray and reconnect. GO to F2.
- Using the Jaguar Land Rover approved diagnostic equipment, check for DTC
P2B83 set in the PCM
- F2: PCM DIAGNOSTIC TROUBLE CODE REPAIR ACTIONS P2B83 DRY RUNNING 2
- Clear the DTC
s and retest
Is the coolant pump now running correctly?
Yes: If the coolant pump is running correctly, Check for other DTC s and restart the diagnostic if necessary
No: If the coolant pump is not running, install a new coolant pump as necessary
- Clear the DTC
s and retest