Ignition Coil-On-Plug (G2344516): Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Position the charge air cooler in the service position.
Refer to: CHARGE AIR COOLER SERVICE POSITION
Remove the air filter outlet pipe.
Refer to: AIR FILTER OUTLET PIPE
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the Noise, Vibration and Harshness (NVH) material.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the fuel injector wiring harness electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove the 2 Noise, Vibration and Harshness (NVH) components.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the breather hose.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the 6 electrical connectors from the 6 ignition coil on-plugs.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 6 bolts.
- Remove the 6 ignition coil-on-plugs.