LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine - V8 S/C 5.0L Petrol -- Defender/L663 (1 Of 2)) >> Engine - V8 S/C 5.0L Petrol (G2796528) >> Removal And Installation >> Valves (G2796555) >> Removal

Valves (G2796555): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Disconnect the 12 V system.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

  2. Raise and support the vehicle on a suitable 2 post lift

    Refer to: JACKING AND LIFTING

  3. Remove the left cylinder head.

    Refer to: LEFT CYLINDER HEAD 

  4. Remove the right cylinder head.

    Refer to: RIGHT CYLINDER HEAD 

  5. CAUTION: If the cylinder head valve components are to be reused, mark position of the valve components to make sure they are reassembled in the same position.
    NOTE: Repeat this procedure for the remaining valves.
    G11607195Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Install the special tool and compress the valve spring.

      Special Tool(s): 303-252 

    • Remove the 2 collets.
    • Decompress the valve spring and remove the special tool.
    • Remove the valve spring cap and the valve spring.
  6. NOTE: Repeat this procedure for the remaining valves.
    G11607196Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the valve.

  7. NOTE: Repeat this procedure for the remaining valves.
    G11607197Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Use the special tool to remove and discard the valve stem seal.

    Special Tool(s): 303-884 

  8. CAUTION:
    • Make sure that the area around the component is clean and free of foreign material.
    • Make sure the working surfaces are thoroughly clean to avoid contamination of the sensitive components.
    • Make sure that the valve grinding paste is kept away from the valve stem.
    G11607198Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Place a small amount of fine valve grinding paste evenly around the contact face of the valve.
    • Place the valve in position and using a suitable valve grinding tool, rotate the valve back and forth a few degrees on its seat, using light pressure.
    • Raise the valve frequently during lapping and turn it into a new position after a few laps or rotations.
    • Lap only until a continuous but narrow lapping mark is visible on both the valve seat and valve face.
    • Thoroughly clean all surfaces to remove traces of valve grinding paste from the cylinder head, valve seat and valve face.
  9. Repeat the procedure for the remaining valves.
scientia non olet · About LEMON Manuals