Crankshaft Rear Seal (G2796539): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Both flange surfaces must be free from oil or detritus contamination.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Clean the oil pan and cylinder block mating faces.
- Apply RTV sealant diameter of 3mm from the inner edge of the oil pan outwards following the 'T' joint line as illustrated.
  Refer to: SPECIFICATIONS
CAUTION: Make sure that crankshaft rear seal and cover is installed directly over the bolt holes so that the sealer is not smeared.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the special tool.
  Special Tool(s): 303-1442
- Install a new crankshaft rear seal and cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install, but do not fully tighten the 4 bolts.
- Remove the special tool.
  Remove the Special Tool(s): 303-1442
NOTE: Positional tolerance of the crankshaft rear seal to the crankshaft palm is 0.2mm.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the special tool.
  Special Tool(s): JLR-303-1622
- Align the crankshaft rear seal and cover.
Fig 1: Crankshaft Rear Seal Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the 4 bolts in the sequence illustrated.

Torque : 11.5 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install and tighten the 8 bolts.
  Torque : 11.5 Nm
- Remove the special tool.
  Remove the Special Tool(s): JLR-303-1622
Install the drive plate.
Refer to: DRIVE PLATE
Connect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT