Starter Motor (G2768462): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Only do the following step(s) if the component was previously removed.
- Install the heatshield to the starter motor.
- Install and tighten the 3 bolts.
  Torque : 10 Nm
- Install a new starter motor gasket.
  Renew Part: Starter motor gasket Quantity: 1 .
- Install the starter motor.
- Install and tighten the 2 bolts.
  Torque : 48 Nm
- Connect the 2 wiring harnesses.
- Install and tighten the 2 nuts.
  Torque : 7 Nm
Position the startup battery positive cable cover in place.
Install the transmission undershield.
Refer to: TRANSMISSION UNDERSHIELD
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD
Connect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT