Front Silencer (G2823263): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 2 electrical connectors from the 2 exhaust actuator control valves.
- Release the wiring harness from the 4 clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the 2 front exhaust clamps.
- Release the 2 front exhaust mounting rubbers.
- Release the 4 rear exhaust mounting rubbers.
- With assistance remove the exhaust rear section.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use special tool to cut the exhaust pipes at the factory mark as illustrated.

Special Tool(s): 100-051