Charging Socket Plug Lock (G2781482): Installation

WARNING: This page is about a different variant/trim than selected.

Install the charging socket plug lock release cable.
- Install the charging socket plug lock.
- Install and tighten the 2 bolts.
  Torque : 1.2 Nm
- Connect the electrical connector.
CAUTION: Take extra care not to damage the component.
- Reposition the charging socket assembly into the correct position.
- Install and tighten the 2 bolts.
  Torque : 10 Nm
- Install and tighten the 2 nuts.
  Torque : 10 Nm
- Install the emergency release cable.
- Close the cover.
NOTE: If equipped.
- Install the 2 ground cables.
- Install and tighten the 2 ground cable nuts.
  Torque : 10 Nm
NOTE: If equipped.
- Install the ground cable.
- Install and tighten the ground cable nut.
  Torque : 10 Nm
Install the 7 HV harness clips in the area of the left wheel arch.
Install the diagnostic module tank leakage pump.
Refer to: DIAGNOSTIC MODULE TANK LEAKAGE PUMP - INGENIUM I4 2.0L PETROL - PHEV
Install the charging socket flap.
Refer to: CHARGING SOCKET FLAP