Auxiliary Battery (G2806382): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the auxiliary battery.
- Connect the auxiliary battery positive cable.
  Torque : 6 Nm
- Install the positive terminal cover on the auxiliary battery.
- Connect the auxiliary battery ground cable.
  Torque : 6 Nm
- Install the bracket.
- Install and tighten the 4 nuts.
  Torque : 10 Nm
- Install and tighten the bolt.
  Torque : 12 Nm
- Install the clip.
- Install the auxiliary battery junction box.
- Install and tighten the 2 nuts.
  Torque : 10 Nm
- Connect the electrical connector.
- Install the vent hose.
- Install the loadspace floor trim.
- Install the 4 D-loop anchor points.
- Install and tighten the 4 bolts.
  Torque : 24 Nm
Close the tailgate.
Connect the 12 V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT