Crankshaft Pulley - INGENIUM I4 2.0L Petrol (G2344447): Installation

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install a new crankshaft front seal to the special tool.
  Renew Part: Crankshaft front oil seal Quantity: 1 .
- Use the special tool to install the crankshaft front seal.
- Tighten the crankshaft front seal.
  Torque : 26 Nm
CAUTION: Make sure that the crankshaft pulley is correctly located on the dowel.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the crankshaft pulley.
- Install the special tool.
  Special Tool(s): JLR-303-1630
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Before installing the new crankshaft pulley bolts check the length of the threads as illustrated.
- The new bolts must be 48mm in length.
- Working in a diagonal sequence, install and tighten the 4 new crankshaft pulley bolts.
  Renew Part: Crankshaft pulley bolts Quantity: 4 .
  
  Torque
  
  Stage 1: 37 Nm
  
  Stage 2: 90°
Remove the special tool.
Special Tool(s): JLR-303-1630
Install the accessory drive belt.
Refer to: ACCESSORY DRIVE BELT - INGENIUM I4 2.0L PETROL
Connect the startup battery ground cable.
Refer to: SPECIFICATIONS