LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Fuel Charging And Controls - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- Range Rover Velar/L560) >> Fuel Charging And Controls - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV >> Removal And Installation >> Fuel Pump Driver Module (G2054366) >> Installation

Fuel Pump Driver Module (G2054366): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the Fuel Pump Driver Module (FPDM).

    Torque  : 11 Nm 

  2. Connect the FPDM electrical connector.
  3. Connect both rear seat occupancy sensor electrical connectors.
    • Install the rear seat cushion.
  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals