Thermostat Housing (G1998228): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the thermostat housing.
  Torque : 12 Nm
Connect the 2 electrical connectors.
- Connect the coolant bypass hose to the thermostat housing.
  Torque : 7 Nm
Connect the coolant outlet hose to the thermostat housing.
Connect the 2 coolant hoses.
Install the NVH pad.
Fill the cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV .