LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Cooling - INGENIUM I4 2.0L PETROLL/INGENIUM I4 2.0L Petrol PHEV -- Range Rover Velar/L560) >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV >> Removal And Installation >> Radiator (G2135455) >> Removal

Radiator (G2135455): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING .

  2. Disconnect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

  3. Drain the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .

  4. Remove the cooling fan and motor shroud.

    Refer to: ELECTRIC COOLING FAN AND SHROUD (G2135451)  .

  5. G14286133Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the radiator support bracket.

  6. CAUTION: Be prepared to collect escaping coolant.
    G14286134Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the radiator assembly.