LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Cooling - INGENIUM I4 2.0L PETROLL/INGENIUM I4 2.0L Petrol PHEV -- Range Rover Velar/L560) >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV >> Removal And Installation >> Radiator (G2135455) >> Installation

Radiator (G2135455): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the radiator assembly into the correct position. Make sure that the 2 retaining clips are correctly located.
  2. Install the radiator support bracket and tighten the 2 bolts to the correct torque.

    Torque  : 9 Nm 

  3. Install the cooling fan and motor shroud.

    Refer to: ELECTRIC COOLING FAN AND SHROUD (G2135451) .

  4. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .

  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

scientia non olet · About LEMON Manuals