Engine Coolant Temperature Sensor (G2278272): Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Since injury such as scalding could be caused by escaping steam or coolant, do not remove the engine coolant temperature sensor while the system is hot.
- Be prepared to collect escaping coolant.
NOTE:
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- Remove the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV .
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
- Remove the engine undershield.
Refer to: ENGINE UNDERSHIELD .
- Drain the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
Disconnect the electrical connector from the Engine Coolant Temperature (ECT) sensor.
- Remove the ECT sensor clip.
- Remove the ECT sensor.