LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Cooling - INGENIUM I4 2.0L PETROLL/INGENIUM I4 2.0L Petrol PHEV -- Range Rover Velar/L560) >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV >> Removal And Installation >> Auxiliary Radiator (G1998223) >> Installation

Auxiliary Radiator (G1998223): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the auxiliary radiator.
    • Make sure the 3 clips are correctly installed.
    • Install and tighten the 2 bolts.

      Torque  : 7 Nm 

  2. Install and tighten the auxiliary radiator bracket bolt.

    Torque  : 7 Nm 

  3. Connect the upper coolant hoses.
  4. Connect the lower coolant hoses.
  5. Install the front right wheel arch liner.

    Refer to: FRONT WHEEL ARCH LINER .

  6. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .

  7. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD .

scientia non olet · About LEMON Manuals