Right Engine Mount (G2523496): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the engine mount.
- Install and tighten the 2 new engine mount bolts.
  Renew Part: Engine mount bolt(s) Quantity: 2 .
  
  Torque : 47 Nm
CAUTION: Make sure the engine mount guide pin in the correct position on both side.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use the special tool 303-021 to lower the engine until the engine bracket rests on the engine mounts.
Install and tighten the new engine mount nut.
Renew Part: Right powertrain mount nut Quantity: 1 .

Torque : 60 Nm
- Install the heat shield.
- Install the 2 bolts.
  Torque : 20 Nm
Remove the engine support bracket.
Special Tool(s): 303-021
- Remove the bolt.
- Remove the engine lifting bracket.
  Special Tool(s): JLR-303-1633
Install the cowl panel.
Refer to: COWL PANEL .
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD .