Fuel Tank (G2132467): Installation

WARNING: This page is about a different variant/trim than selected.

The following step(s) applies to:

Vehicles with fuel fired heater

Install the 3 fuel pipes to the 5 clips.
The following step(s) applies to:

All vehicles
Install the 2 fuel pipes to the 4 clips.
CAUTION: Care must be taken to avoid damaging the surrounding components.

Position the fuel tank on a suitable stand.
Raise the fuel tank.
- Install the fuel tank.
- Install the fuel tank mounting brackets and finger tighten the 4 nuts.
- Tighten the 4 nuts.
  Torque : 25 Nm
The following step(s) applies to:

Vehicles with fuel fired heater
Connect the Fuel Fired Booster Heater (FFBH) fuel return pipe.
Connect the 2 FFBH fuel delivery pipes.
The following step(s) applies to:

All vehicles
Connect the 2 fuel delivery pipes.
Install the fuel tank shield and tighten the 5 nuts.
NOTE: If equipped.

Install the 2 fuel tank shields and the 2 nuts.
- Install the clamp to the fuel filler hose.
- Connect the fuel filler hose to the fuel tank.
- Tighten the clamp.
- Install the left side undershield and the 12 bolts.
- Install the right side undershield and the 12 bolts.
- Install the 21 fasteners.
Install the driveshaft.
Refer to: REAR DRIVESHAFT - INGENIUM I4 2.0L PETROL - PHEV
Connect the breather to the fuel tank.
Install the fuel pump and sensor unit.
Refer to: FUEL PUMP DRIVER MODULE

Refer to FUEL PUMP DRIVER MODULE .
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT