Fuel Pump Driver Module
WARNING: This page is about a different variant/trim than selected.
The FPDM is located behind the right second row seat. The FPDM is attached to a bracket and secured by 2 nuts to the rear underfloor reinforcement panel.
The LP fuel pump operation is controlled by the FPDM which is controlled by the PCM . The FPDM receives a Pulse Width Modulated (PWM) signal from the PCM . The FPDM outputs the required power to the LP fuel pump to provide the fuel flow and pressure output.
The FPDM has a single wiring harness connector. The wiring harness connector has the following connections:
- Power supply from the fuel pump relay in the Rear Junction Box (RJB).
- PWM signal from the PCM .
- Power to the LP fuel pump in the LP fuel pump assembly. (Quantity 3)
- Ground for the LP fuel pump in the LP fuel pump assembly.
- Ground.