LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Fuel Tank And Lines - INGENIUM I4 2.0L Petrol -- Range Rover Velar/L560) >> Fuel Tank And Lines - INGENIUM I4 2.0L Petrol (G2006682) >> Description And Operation >> Fuel Tank And Lines - INGENIUM I4 2.0L Petrol (G2789298) >> Description >> Fuel Level Sensors - Plug-In Hybrid Electric Vehicles Only

Fuel Level Sensors - Plug-In Hybrid Electric Vehicles Only

WARNING: This page is about a different variant/trim than selected.

There are 2 fuel level sensors used to measure the amount of fuel, remaining in the left and right sides of the fuel tank. There are 2 fuel level sensors installed in the fuel tank. The fuel level sensor 'A' and fuel level sensor 'B' are attached to the fuel tank internal brackets on each side of the fuel tank. Both sensors are connected to the vehicle wiring harness through the external electrical connector on the LP  fuel pump assembly top flange assembly.

The fuel level sensor signals are converted into CAN  bus messages by the BCM  /GWM  and used by the IPC  for fuel gauge and fuel warning indicator operation. Also monitored by the PCM  to store DTC  for misfire detection when the fuel level is below a predetermined capacity.

scientia non olet · About LEMON Manuals