Exhaust System - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2524047): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: This step is only required if previously removed.
- Install the exhaust cross brace.
- Install the 2 exhaust mounting rubbers.
CAUTION: Make sure the exhaust system is supported at all times.
- With assistance from another technician, install the exhaust system.
- Install the 2 exhaust mounting rubbers.
- Install and tighten the 4 bolts.
  Torque : 25 Nm
Install and tighten the new front exhaust clamp.
Renew Part: Front exhaust clamp Quantity: 1 . Part Number:

Torque : 56 Nm
- Install the center undershield.
- Install and tighten the 2 nuts.
  Torque : 5 Nm
- Install and tighten the 4 bolts.
  Torque : 5 Nm
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD .
Connect the 12V system.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .