Exhaust Back Pressure Sensor (G2401320): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the bracket to the differential pressure sensor.
- Install and tighten the bolt.
  Torque : 7 Nm
- Install the cover.
- Secure the 3 clips.
- Install the differential pressure sensor assembly.
- Install and tighten the bolt.
  Torque : 9 Nm
- Connect the electrical connector.
- Connect the differential pressure sensor high pressure hose.
- Secure the clip.
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD .
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV .