LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV >> Removal And Installation >> Rear Knock Sensor (G2031026) >> Installation

Rear Knock Sensor (G2031026): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the knock sensor.
    • Torque  : 20 Nm 
  2. Connect the electrical connector.
  3. Install the intake manifold.

    Refer to: INTAKE MANIFOLD .

  4. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals