Post Catalyst Heated Oxygen Sensor (G2271369): Installation

WARNING: This page is about a different variant/trim than selected.

- Using the special tool, install the post catalyst heated oxygen sensor.
  Special Tool(s): JLR-303-1666
  
  Torque : 48 Nm
- If the sensor is not being replaced with a new component. Make sure that a suitable anti seize grease is applied to the sensor thread.
Install the clips.
Connect the post catalyst heated oxygen sensor electrical connector.
Install the air deflector.
Refer to: ENGINE UNDERSHIELD
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT