Piston Cooling Oil Jet Solenoid (G2130910): Installation
WARNING: This page is about a different variant/trim than selected.
The following step(s) applies to:
All vehicles
-
- Install the Piston Cooling Jet (PCJ) Solenoid.
- Inspect the O-ring. Replace if damaged.
- Torque : 11 Nm
- Connect the electrical connector.
The following step(s) applies to:
Cold climate vehicles
- Install the block heater.
Refer to: BLOCK HEATER .
The following step(s) applies to:
All vehicles
- Install the generator.
Refer to: GENERATOR