Intake Camshaft Position Sensor (G2020274): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Apply a thin film of Castrol Classic GP-50 to the camshaft position sensor bore.
- Install the intake camshaft position sensor.
  Renew Part: Camshaft position sensor O-ring seal Quantity: 1 .
- Install and tighten the bolt.
  Torque : 8 Nm
- Connect the electrical connector.
- Connect the breather pipe.
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV
Connect the startup battery ground cable.
Refer to: SPECIFICATIONS