Fuel Rail Pressure Sensor (G2289191): Installation

WARNING: This page is about a different variant/trim than selected.

Authoring Template
CAUTION: Make sure threads are clean and free from petrol.

Install the fuel rail pressure sensor. Lubricate the threads with Molykote W15.

Torque : 38 Nm
Connect the electrical connector to the fuel rail pressure sensor.
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV
Connect the startup battery ground cable.
Refer to: SPECIFICATIONS