Starter Motor (G2110302): Installation
WARNING: This page is about a different variant/trim than selected.
- Connect the breathers.
- Install the starter motor.
Torque : 48 Nm
- Connect the wiring harness nut.
Torque : 7 Nm
-
- Connect the battery cable.
Torque : 12 Nm
- Secure the cover.
- Connect the battery cable.
- Install the catalytic converter.
Refer to: CATALYTIC CONVERTER AND GASOLINE PARTICULATE FILTER ASSEMBLY - VEHICLES WITH: ROW SPECIFICATION (G2524050) .
- Install the engine undershield.
Refer to: ENGINE UNDERSHIELD .
- Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .