Accessory Drive - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2743732): Overview

WARNING: This page is about a different variant/trim than selected.

On non-Plug-in Hybrid Electric Vehicle (PHEV) the accessory drive provides power from the crankshaft by the crankshaft pulley through the accessory drive belt to drive front mounted accessories such as:

The generator
- For additional information, Refer to: GENERATOR .
The engine coolant pump
- For additional information, Refer to: ENGINE COOLING .
The A/C compressor.
- For additional information, Refer to: AIR CONDITIONING .

On PHEV the accessory drive provides power from the crankshaft by the crankshaft pulley through the engine coolant pump drive belt to drive the engine coolant pump.

For additional information, Refer to: ENGINE COOLING .

The 12V BISG does not operate as a generator in this configuration, this is used as a starter motor on the PHEV . The BISG is connected to the crankshaft pulley by a BISG drive belt.

For additional information, Refer to: STARTING SYSTEM - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV (G2743734) .

The drive belt must be at the correct tension to make sure the torque is transmitted without slip.