LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Ignition - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Engine Ignition - V8 S/C 5.0L Petrol (G2318594) >> Removal And Installation >> Ignition Coil-On-Plug (G2244125) >> Installation

Ignition Coil-On-Plug (G2244125): Installation

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the ignition coil-on-plug.
    • Install the bolt.

      Torque  : 7 Nm 

  2. Connect the electrical connector.
  3. Repeat steps  1 and  2 for the remaining ignition coil-on-plugs for Bank 2
    • Remove the oil filler cap.
    • Install the Noise, Vibration and Harshness (NVH) material.
    • Install the oil filler cap.
  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

scientia non olet · About LEMON Manuals