LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Starting System - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Starting System - V8 S/C 5.0L Petrol (G2270684) >> Removal And Installation >> Starter Motor (G2268810) >> Installation

Starter Motor (G2268810): Installation

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Before installing the starter motor bolts, note the thread size of the bolts.
    • Install the starter motor.
    • Install and tighten the 2 bolts.

      Torque  : 48 Nm 

    • Install the heatshield to the starter motor.
    • Install and tighten the 2 bolts.

      Torque  : 6 Nm 

    • Position the negative cable to the starter motor.
    • Install and tighten the nut.

      Torque  : 7 Nm 

    • Position the positive cable to the starter motor.
    • Install and tighten the nut.

      Torque  : 12 Nm 

  5. NOTE: Make sure that all the clips are correctly installed.

    Install the cover.

  6. Install the right catalytic converter.

    Refer to: RIGHT CATALYTIC CONVERTER

  7. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals