Fuel Charging And Controls - V8 S/C 5.0L Petrol (G2318592)
WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
- Before any work is carried out on the fuel system, ground the vehicle to earth and maintain the ground connection until the work is complete.
CAUTION:
Before disconnecting or removing components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
NOTE:
- *Tighten the fuel rail high pressure fuel pump fuel line unions and fuel rail crossover pipe unions as it is instructed in the service information.
- *Following installation of the spark plugs, visually inspect the paint mark on the terminal of the spark plug for correct orientation. The head of the 'T' paint mark must face the fuel injector within ± 45°.
TORQUE SPECIFICATIONS
| DESCRIPTION | NM | LB-FT | LB-IN |
|---|---|---|---|
| Ignition coil-on-plugs retaining bolts | 7 | - | 62 |
| *Spark plugs | 23 | 17 | - |
| Fuel rail retaining bolt | 30 | 22 | - |
| Fuel crossover line retaining bolts | 8 | - | 71 |
| *Fuel line unions | 21 | 15 | - |
| High Pressure (HP) fuel line M8 bolt | 25 | 18 | - |
| HP fuel line M6 bolt | 11 | 8 | - |
| HP fuel line M5 nut | 6 | - | 53 |
| HP fuel line shield M10 bolt | 29 | 21 | - |
| HP fuel line shield M6 bolt | 11 | 8 | - |
| HP fuel pump bolts | 11 | 8 | - |
| Throttle body retaining bolts | 10 | 7 | 88 |
| Accessory drive belt idler pulley bracket retaining bolts | 25 | 18 | - |
| Halfshaft support bracket bolts | 25 | 18 | - |
| Engine mount bracket bolts | 48 | 35 | - |
| Engine mount top nut | 48 | 35 | - |
| Fuel Pump Driver Module (FPDM) nuts | 11 | 8 | - |