Thermostat Housing (G2244106): Installation
WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
- Install the thermostat housing. Install and tighten the bolt.
Torque : 10 Nm
- Connect the 2 upper coolant hoses to the thermostat housing.
-
- Connect the electrical connector and secure the 2 wiring harness clips.
- Connect the 2 lower coolant hoses to the thermostat housing.
- Connect the 2 coolant hoses to the charge air cooler and secure the clip.
- Install the left air filter.
Refer to: LEFT AIR FILTER HOUSING
- Install the air filter outlet pipe T-connector.
Refer to: AIR FILTER OUTLET PIPE T-CONNECTOR
- Vacuum fill the cooling system.