LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Cooling - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Engine Cooling - V8 S/C 5.0L Petrol >> Removal And Installation >> Cooling Module (G2292257) >> Installation

Cooling Module (G2292257): Installation

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cooling module. Install and tighten and 4 bolts.

    Torque  : 9 Nm 

    • Install the cooling module protector.
    • Install and tighten the 4 bolts.

      Torque 

      M12 Bolts: 90 Nm 

      M10 Bolts: 45 Nm 

  3. CAUTION: Take care not to damage the O-ring seals during installation.
    • Install the upper Air Conditioning (A/C) pipe and new O-ring seal. Install and tighten the bolt.

      Renew Part: Air conditioning pipes O-ring seals Quantity: 2 . 

      Torque  : 20 Nm 

    • Install the lower A/C pipe and new O-ring seal. Install and tighten the nut.

      Renew Part: Air conditioning pipes O-ring seals Quantity: 2 . 

      Torque  : 20 Nm 

  4. Connect the left side coolant hose to the charge air radiator.
  5. Connect the right side upper coolant hose to the radiator.
  6. Connect the degas pipe.
    • Connect the hose to the charge air radiator and secure the clip.
    • Install the coolant pump. Install and tighten the bolt

      Torque  : 9 Nm 

  8. Connect the electrical connector to the coolant pump.
  9. Connect the left side coolant hose to the radiator.
  10. Secure the 4 coolant hose clips to the cooling fan shroud.
  11. Connect the right side lower coolant hose to the radiator and secure the 2 clips to the cooling fan shroud.
  12. Connect the 2 electrical connectors.
  13. Install the 2 mounting brackets. Install and tighten the 6 bolts.

    Torque  : 9 Nm 

  14. Install the air duct.
    • Connect the air duct to the left side air filter housing.
    • Connect the air duct to the right side air filter housing.
  16. Install the left air filter outlet pipe.

    Refer to: LEFT AIR FILTER OUTLET PIPE

  17. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  18. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  19. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING 

  20. Install the front bumper.

    Refer to: FRONT BUMPER

  21. Charge the A/C system.

    Refer to: AIR CONDITIONING SYSTEM RECOVERY, EVACUATION AND CHARGING

scientia non olet · About LEMON Manuals