Coolant Pump (G2244104): Installation

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Observe correct installation of the coolant pump to oil cooler tube o-ring seals. Failure to do so may result in coolant loss.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Make sure that the coolant pump to oil cooler tube o-ring seals are correctly installed.
- Install the new O-ring seals and gaskets.
  Renew Part: Oil cooler to water pump O-ring seals Quantity: 2 .
  
  Renew Part: Engine coolant pump gasket Quantity: 2 .
- Install the coolant pump. Install and tighten the 4 bolts.
  Torque : 12 Nm
Install the coolant pump pipe.
- Install the accessory drive belt tensioner.
- Install and tighten the bolt.
  Torque : 40 Nm
CAUTION:
- Make sure that the accessory drive belt is correctly located on each pulley.
- Clean the accessory drive belt pulleys and inspect for damage.
Install the accessory drive belt.
Install the coolant pump hose and the hose clamp.
Install the supercharger belt.
Refer to: SUPERCHARGER BELT
Vacuum fill the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT