LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Engine - V8 S/C 5.0L Petrol >> Removal And Installation >> Right Engine Mount (G2318614) >> Installation

Right Engine Mount (G2318614): Installation

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the right engine mount.
  2. WARNING: Make sure the engine is properly located on the engine mounts.

    Lower the engine.

    General Equipment: Transmission jack 

  3. CAUTION: Only tighten the nuts and bolt finger-tight at this stage.
    • Install, but only finger tight the 2 right engine mount bolts.
    • Install, but only finger tight the right engine mount nut.
  4. Install, but only finger tight the left engine mount nut.
  5. NOTE: Repeat this step for both sides.
    • Fully tighten the 2 engine mount bolts at both sides.

      Torque  : 47.5 Nm 

    • Fully tighten the engine mount nut at both sides.

      Torque  : 60 Nm 

  6. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD .

  7. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

scientia non olet · About LEMON Manuals