LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Engine - V8 S/C 5.0L Petrol >> Removal And Installation >> Drive Plate (G2246997) >> Removal

Drive Plate (G2246997): Removal

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING .

  2. Disconnect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

  3. Remove the transmission assembly.

    Refer to: the appropriate Service Information.

  4. CAUTION: The bolts can only be used 3 times, mark the bolts with a center punch. If 2 punch marks are visible, discard the bolts.
    G11606922Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Install the special tool as illustrated. Tighten the 2 bolts on the special tool to the correct torque.

      Special Tool(s): JLR-303-1304 

      Torque  : 10 Nm 

    • Release the 10 bolts on the drive plate and remove the drive plate.
scientia non olet · About LEMON Manuals