U2108-64: Adaptive Cruise Control - Signal plausibility failure: Action

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The FlexRay wiring harness must not be repaired by making a localised wiring repair. A new wiring harness should be installed.

Refer to the electrical circuit diagrams and check the adaptive Cruise Control Module power and ground circuits for open circuit, high resistance. Repair the wiring harness as necessary
Using the Jaguar Land Rover approved diagnostic equipment, perform a CAN network integrity test. Refer to the electrical circuit diagrams and check the high speed CAN bus (chassis) circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
Refer to the electrical circuit diagrams and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the adaptive Cruise Control Module for related DTCs and refer to the relevant DTC index