Right Catalytic Converter (G2272666): Installation

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:
- This step is only required if previously removed.
- Make sure that a suitable anti seize grease is applied to the sensor thread.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool Install and tighten the Heated Oxygen Sensors (H02S).

Special Tool(s): 310-121

Torque : 48 Nm
- Install the right catalytic converter.
- Install and tighten the 2 new nuts.
  Renew Part: Exhaust manifold nuts Quantity: 2 .
  
  Torque : 40 Nm
- Connect the HO2S electrical connector.
- Install the wiring harness to the clip.
- Install the heatshield.
- Install and tighten the 3 bolts.
  Torque : 9 Nm
- Connect the HO2S electrical connector.
- Install the wiring harness to the 2 clips.
Install the front silencer.
Refer to: FRONT SILENCER .
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD .