LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Removal And Installation >> Manifold Absolute Pressure Sensor (G2244157) >> Installation

Manifold Absolute Pressure Sensor (G2244157): Installation

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the Manifold Absolute Pressure (MAP) sensor.
    • Install and tighten the bolt.

      Torque  : 5 Nm 

    • Connect the electrical connector.
  2. Install the vacuum pipe to the 2 clips.
    • Connect the vacuum pipe.
    • Install the vacuum pipe to the clip.
  4. Install the secondary bulkhead left inner panel.

    Refer to: SECONDARY BULKHEAD LEFT INNER PANEL - INGENIUM I6 3.0L PETROL

  5. Install the secondary bulkhead left outer panel.

    Refer to: SECONDARY BULKHEAD LEFT OUTER PANEL

scientia non olet · About LEMON Manuals