LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Removal And Installation >> Left Mid Catalyst Heated Oxygen Sensor (G2244156) >> Installation

Left Mid Catalyst Heated Oxygen Sensor (G2244156): Installation

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure that the mating faces are clean and free of corrosion and foreign material.
    • Make sure the anti-seize compound does not contact the HO2S tip.
    • If accidentally dropped or knocked install a new sensor.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
    • Using the special tool, install the left Heated Oxygen Sensor (HO2S).

      Special Tool(s): JLR-303-1666 

      Torque  : 48 Nm 

    • Connect the electrical connector and secure the clips.
  2. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

scientia non olet · About LEMON Manuals