LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Removal And Installation >> Engine Coolant Temperature Sensor (G2249553) >> Removal

Engine Coolant Temperature Sensor (G2249553): Removal

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING

  2. Drain the engine cooling system.

    Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING

  3. Remove the secondary bulkhead right inner panel.

    Refer to: SECONDARY BULKHEAD RIGHT INNER PANEL - INGENIUM I6 3.0L DIESEL

  4. WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do not remove the engine coolant temperature sensor while the system is hot.
    CAUTION: Be prepared to collect escaping coolant.
    G14290057Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Disconnect the electrical connector.
    • Remove the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals