LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Velar R-Dynamic HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Range Rover Velar/L560) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Description And Operation >> Electronic Engine Controls - V8 S/C 5.0L Petrol (G2318514) >> Operation >> Crankshaft Position Sensor

Crankshaft Position Sensor

WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.

The characteristics of the signal supplied by the Crankshaft Position (CKP) sensor are learned by the Powertrain Control Module (PCM). This enables the PCM to set an adaption and support the engine misfire detection function. There are small variations between different drive plates and different CKP sensors. The adaption must be reset if either component is renewed, or removed and installed. It is also necessary to reset the drive plate adaption if the PCM is renewed or replaced.

The PCM supports 4 drive plate adaptions for the CKP sensor. Each adaption relates to a specific engine speed range. The engine speed ranges are detailed in the table below:

ADAPTION ENGINE SPEED - REVOLUTION PER MINUTE (RPM)
1 1, 800 - 3, 000
2 3, 001 - 3, 800
3 3, 801 - 4, 600
4 4, 601 - 5, 400
scientia non olet · About LEMON Manuals