P0333-22: Knock/Combustion Vibration Sensor 2 Circuit High Bank 2 - Signal amplitude > maximum: Action
WARNING: This page is about a different car, the 2020 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
Knock sensor bank 2 front
- Refer to the electrical circuit diagrams and check knock sensor circuit for short circuit to power
- Measure knock sensor circuit for correct resistance
- Knock sensor shunt resistor (resistance between 2 signal lines) 4.9 Mega Ohms +/- 20%
- Inspect connectors for signs of water ingress and pins for damage and/or corrosion
- Check for abnormal engine noise that may corrupt the knock sensor signal
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest
- Install new knock sensor, only when diagnosed as failed