Electric Cooling Fan And Shroud (G2749592): Installation

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the wiring harness.
- Install the electrical connector clip.
- Install the 2 wiring harness clips.
CAUTION: Make sure that the locating pegs are correctly installed.

Install the electric cooling fan and shroud.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the 7 coolant hose clips.
- Connect the coolant hose connector.
NOTE: Vehicles with right auxiliary radiator.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the 3 coolant hose clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the 4 wiring harness clips.
- Connect the 4 electrical connectors.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the radiator 2 upper mounting brackets.
- Install and tighten the 8 bolts.
  Torque : 9 Nm
CAUTION: Take extra care not to damage the component.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the breather pipe.
- Install the 4 pipe clips.
- Connect the 3 coolant pipe connectors.
- Install the wiring harness clip.
- Connect the electrical connector.
NOTE: Repeat this step for the other side.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the cooling module upper mounting bracket.
- Install and tighten the 2 bolts.
  Torque : 7 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the 2 dirty air ducts at the 7 clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the air deflector.
- Install the 2 dirty air ducts at the 6 clips.
Install the radiator grille.
Refer to: RADIATOR GRILLE
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD
Fill the engine cooling system with the correct amount of coolant fluid.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Connect the 12V system.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT