Coolant Pump (G3186294): Installation

- Install the new O-ring seal.
  Renew Part: Engine coolant pump O-ring seal Quantity: 1 .
- Install the coolant pump.
- Install and tighten the 3 new bolts.
  Renew Part: Coolant pump bolts Quantity: 3 .
  
  Torque : 25 Nm
- Connect the 2 electrical connectors.
- Install the coolant pump pulley.
- Install the 3 bolts finger tight at this stage.
Install the accessory drive belt.
Refer to: ACCESSORY DRIVE BELT
Tighten the coolant pump pulley bolts.
Torque : 25 Nm
Install the electric cooling fan and shroud.
Refer to: ELECTRIC COOLING FAN AND SHROUD
Fill the engine cooling system with the correct amount of coolant fluid.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT