Integrated Electric Park Brake Actuator (G2523159): Installation

- Install a new O-ring seal.
  Renew Part: Electric park brake actuator O-ring seal and bolt kit Quantity: 1 .
- Install the EPB actuator to the brake caliper.
- Install and tighten the 2 new bolts.
  Torque : 8 Nm
Connect the electrical connector to the EPB actuator.
NOTE: This step is only required if the JLR diagnostic equipment is not available.

Disable the EPB maintenance mode.

Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
Connect the JLR approved diagnostic equipment and disable the EPB maintenance position.
General Equipment: Jaguar Land Rover approved diagnostic equipment
Use the JLR approved diagnostic equipment and disable the Integrated Power Brake assembly mode.
Refer to: INTEGRATED POWER BRAKE ASSEMBLY MODE