Electric Park Brake Release When The Vehicle Has No Electrical Power (G2131550): Check

NOTE: This procedure contains illustrations for left side components, right side components are similar.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the rear wheel and tire.
Refer to: WHEEL AND TIRE
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the electrical connector.
NOTE: Remove and discard the O-ring seal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the Electric Park Brake (EPB) actuator.

Renew Part: Electric park brake actuator O-ring seal Quantity: 2 .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Turn the caliper piston clockwise to set the rear brake caliper to the maintenance position.
CAUTION: A new O-ring seal is to be installed.

Install the EPB actuator.

Torque : 11 Nm
Connect the electrical connector.
Repeat the above procedure for the other side.
Install the rear wheel and tire.
Refer to: WHEEL AND TIRE
Calibrate the Electric Park Brake (EPB) using the Land Rover approved diagnostic tool.